Гидроабразивная установка для резки листового материала, HD-3038A-3040B

Технические характеристики

гидроабразивная установка (CNC ultra-high pressure waterjet cutting machine)рабочий стол размером (3000mm*4000mm)
Water jet cutting machine mainly consists of basic parts: work table with controller,high pressure system. (Bridge type and Fly type)
Technical Parameters:
Working table:3100mm* 4100mm
processing dimention:3000mm* 4000mm
Z axis:150mm
control accuracy:±0.01mm
cutting accuracy:±0.1mm
Re-position accuracy:±0.02mm

water jet machine high pressure system
we have 300mpa,380mpa,420mpa for customer's choose.
high pressure pump is the core of a waterjet cutting machine ,which also can used with other machines together.
The intensifier acts as an amplifier as it converts the energy from the low pressure hydraulic fluid into ultra-high pressure water. The hydraulic system provides fluid power to a reciprocating piston in the intensifier center section. A limit switch, located at each end of the piston travel, signals the electronic controls to shift the directional control valve and reverse the piston direction.
The intensifier assembly, with a plunger on each side of the piston, generates pressure in both directions. As one side of the intensifier is in the inlet stroke, the opposite side is generating ultra-high pressure output. During the plunger inlet stroke, filtered water enters the high pressure cylinder through the check valve assembly. After the plunger reverses direction, the water is compressed and exits as ultra-high pressure water and then enters the pressure vessel(accumulator) The accumulator smoothes pressure fluctuations from the intensifier and delivers a constant and steady stream of ultra-high pressure water to the cutting tool.

Main technical parameters
Maximum operating pressure:380Mpa(55,000psi)
Continuous operating pressure:320-340Mpa
Max. oil discharge:93L/min
Max. water discharge:3.7l/min
Water pressure:0.3MPa
Main motor power:37kw(50Hp)
Power requirement :380V/ 50Hz

CNC controller
run base on windows xp ,english version operation interface,mitsubishi servo motor and driver. Nc studio cutting software,industrial computer 1G memory card. hand- wheel can be chosen.
a) CNC control, apply 19 inch LCD;
b) Adopt specialized water jet cutting software, have autosave function for next operation;
c) Apply Omron brand PLC instead of relay;
d) Windows XP based, Support DXF file and any auto programming software to produce NC code.

water jet machine optional accessories
cooler ,abrasive feeder ,water soften system ,4 axis , lifting arm to load glass etc.
a) abrasive feeder : it can supply the cutting sand quantity according to the adjustable sand level location tube in the sand bin. without any electric connection units, more safety and reliably.
b) water soften system : Seperate the water, extend machine life
c) 4 axis
The main purpose of four-axis cutting head is to compensate tilting degrees, to make the finished edge completely vertical,which the bottom surface geometries are shifted a certain amount to produce the appropriate angle and the Z-axis remains at one height.This cutting head has already performed excellently in many cutting fields to reduce processing cost and increase working efficiency. This can be useful for applications like weld preparation where a bevel angle needs to be cut on all sides of a part that will later be welded, or for taper compensation purposes where the kerf angle is transferred to the waste material - thus eliminating the taper commonly found on water jet-cut parts. In the marble matching process, waterjet cutting with a four-axis cutting head design is simply amazing.There is a more delightful result in marble pattern cutting
d) lifting arm to load glass
The platform can flip, so it is convenient to load and unload materials.

Лицензии и сертификаты

Нет

Доставка и оплата